cancel
Showing results for 
Search instead for 
Did you mean: 

Stamp alignment is borked!

P3nT4gR4m
Consultant
Since the last update I got a problem when I'm using stamps aligned to surface. When I'm moving the stamp about on the surface the red or green ghost is aligned correctly but as soon as I press the trigger it flips the stamp 90 degrees orthogonal to the surface. Thought it might be some problem with the stamp being a pre-update stamp so I made a new one. Same shit 😞

Haven't tried without trigger sensitivity (I rarely ever turn that off these days)
3 REPLIES 3

P3nT4gR4m
Consultant
@nosferalatu
Update on this. Alignment is only borked if I'm sculpting over existing geometry in the same layer. It behaves correctly if I create an empty layer and use constrain to all surfaces. 

nosferalatu
Protege
Yes I can repro the problem. Argh, I'm very sorry about this regression.
Thank you for the update-- that's a very helpful clue. The bug sounds like it's related to the new surface-constraint-to-all-layers code. We'll get this fixed soon.

nosferalatu
Protege
I found the issue. Woops, there was a bug in the surface constraint code when adding clay to the same layer that you are constrained against. The fix will be included in our next update (Real Soon Now).