I ran the Oculus software for about a week or so with no issues. Thought it was time to add the 2nd sensor. Long story short I've been plagued with stuttering and overall bad experience with the 2nd sensor running. So thought I'd go back to one.
I figured unplugging the USB 2.0 sensor and rerunning the full set up would get me back in the game. It didn't.
When I run the full setup it just sits and spins at the check for connections status as shown below:
It's been spinning like that for over 10 minutes.
If I click on SKIP SETUP it warns me about it, I agree to skip setup and it takes me back to the Devices screen.
Do I not need to run the full set up when running only 1 sensor? I actually don't really even recall running it the first time I set it up but thought I missed it or something.