New to the forums? Click here to read the "How To" Guide.

Developer? Click here to go to the Developer Forums.

Unsupported Configuration

soccerdude6soccerdude6 Posts: 22
Brain Burst
I just hooked up a fourth sensor to my Oculus Setup.  I don't know if it is because I am using a unsupported extension cable(I bought a 3.0 usb extension not from Oculus).  Do I need to buy a 2.0 extension or can I not have a fourth sensor?

Comments

  • MorgrumMorgrum Posts: 1,450
    Project 2501
    edited May 2018
    It does that whenever you have a 4th sensor hooked up because its not an offical setup.
    Mine says this everytime but it works juat fine.

    Your two rear sensors should be on 2.0
    WAAAGH!
  • soccerdude6soccerdude6 Posts: 22
    Brain Burst
    Morgrum said:
    It does that whenever you have a 4th sensor hooked up because its not an offical setup.
    Mine says this everytime but it works juat fine.

    Your two rear sensors should be on 2.0
    So hook up rear sensors with 2.0?
  • MorgrumMorgrum Posts: 1,450
    Project 2501
    Yea sir it will help reduce the bandwidth that you put on your usb controller.
    it is the two front cams you want running on 3.0
    WAAAGH!
Sign In or Register to comment.