cancel
Showing results for 
Search instead for 
Did you mean: 

WebXR not working in Oculus Browser on Quest 2

Cloudio23
Level 2

Hi there! 
So, i have problems:
1.) I am more or less new to Oculus and VR-Programming via BabylonJS and WebXR. If you explain something, please do it like you explane it a Programming-Rookie. 😄
2.) I think, since the last update for the Quest 2 it is not longer possible to enter VR-Mode. Not within the examples from the BabylonJS-Tutorials either the threeJS-Examples. If i try this, a blackscreen appears immediately and after a few seconds i can see the oculus browser and the menubar in front of the blackscreen. But sometimes  loadingscrean appears but never stops to load. In both cases i cannot see the controllers but the hoverinteraction while moving. And i cannot exit these states, so i have to restart the Quest 2. 

Does anyone have the same problem or have some more information? 
Thanks in advance for help! 😘

1 ACCEPTED SOLUTION

Accepted Solutions

Cloudio23
Level 2

ok, i figured it out. The Problem was, that i activated the experimental table in the options. That must caused the problem.  👍

View solution in original post

2 REPLIES 2

Cloudio23
Level 2

ok, i figured it out. The Problem was, that i activated the experimental table in the options. That must caused the problem.  👍

View solution in original post

rik.cabanier
Level 2

Yes, if you enable you add a desk to guardian, WebXR stops working. 

This will be fixed in future release.