I struggle to make a flat wall. By default the max size of the clay tool
is no where near large enough. With the new plane feature I thought it
could be done with the stamp that looks like a flat square.. but
unfortunately it's pretty much impossible...
I've only ever exported something with the correct orientation once, and
when I reproduced those steps EXACTLY, the orientation was off again.
I've probably exported 200 times and each time but that once the
orientation is messed up. often times it's...
I am having problems doing this. either the wall is too large because I
didn't subtract enough, or my alignment of the subtract layer isn't
perfectly straight, or it's too thin and so some of it breaks through
the other side. I need a flat, straight ...
These steps worked flawlessly! I dont use RC but regardless, I was able
to import the model into my tool! This is the workflow I am going to go
with. Thank you so much for this @Clampinator! you saved me countless
hours! I can finally sculpt!
could someone break down this workflow and ELI5? I understand that you
need to zero out some scales and orientation, but which layers/objects
and in what order? A very short youtube video where 1 edit to the sculpt
is made (but the size and orientati...